JLG G12-55A AccuPlace Operator Manual - Manual (Page 39)

Section 3 - Controls and Indicators
3-5 3128447
Display
10. Operating Hours: Displays total hours of telehandler operation.
11. Voltmeter: Displays alternator output and battery condition.
12. Engine Speed: Displays engine speed in revolutions per minute (rpm).
13. Engine Fault Indicator: Displays engine fault indicator and fault code if an active
engine fault exists. Code indicates Suspect Parameter Number/Failure Mode
Indicator (SPN/FMI). Contact a local Perkins Engine Distributor for fault code
information.
14. Machine Fault Indicator: Displays machine fault indicator and fault code if an
active machine fault exists (other then engine fault). Code indicates Diagnostic
Trouble Code (DTC). See machine Service Manual for fault code information.
NOTICE
EQUIPMENT DAMAGE. If engine or machine faults become active, immediately
bring machine to a stop, lower boom and attachment to ground and stop the
engine. Determine cause and correct before continued use.
OY1930
XXXXXX.X
XX.X V
XXXX RPM
XXX.XX
XXXXXX.X
XX.X V
XXXX
RPM
XXXX
10
11
12
13
14
10
11
12
DISPLAY SHOWN WITH ENGINE FAULT ACTIVE
DISPLAY SHOWN WITH MACHINE FAULT ACTIVE