JLG G12-55A AccuPlace Operator Manual - Manual (Page 41)

Section 3 - Controls and Indicators
3-7 3128447
Park Brake
Park brake switch controls the application and release of the park brake. Indicator
light on switch illuminates to indicate brake is applied.
• Depress top of switch (1) to engage park brake. With park brake applied,
transmission will not engage forward or reverse.
• Depress bottom of switch (2) to disengage park brake.
Parking Procedure
1. Using service brake, stop telehandler in an appropriate parking area.
2. Follow “Shut-Down Procedure” on page 4-3.
WARNING
MACHINE ROLL-AWAY HAZARD. Always move park brake switch to "ON"
position, lower boom to ground and stop engine before leaving cab.
WARNING
CRUSH HAZARD. Turning engine off applies the park brake. Applying park brake
or turning engine off while traveling will cause unit to stop abruptly and could
cause load loss. Either may be used in an emergency situation.
OY1480
1 2