JLG G12-55A Operator Manual - Manual (Page 100)

Section 5 - Attachments
5-26 3126018
Fork Extension
Use Appropriate Carriage Attachment Capacity Chart
To determine maximum capacity, refer to “Telehandler/Attachment/Fork Capacity” on
page 5-6. The maximum capacity of the carriage when equipped with fork
extensions may be reduced to the capacity indicated on the fork extensions. If the
load exceeds the capacity of the fork extension contact JLG to obtain forks and/or
fork extensions of the proper load rating and length.
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The tilt switch (2) controls fork tilt.
• Press left side of switch to tilt up.
• Press right side of switch to tilt down.
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
page 5-13.
• Ensure length and cross section of the parent fork arm is equal to or exceeds the
parent fork arm blade length stamped into the fork extension.
• Secure the fork extensions to the forks by sliding the fork extensions onto the
parent forks and install the retaining pin behind the vertical shank of the fork.
OZ0750
OAL0662
2
1