JLG 600SC_660SJC Service Manual - Manual (Page 224)

SECTION 6 - JLG CONTROL SYSTEM
6-30 – JLG Lift – 3121607
Table 6-5. Machine Configuration Programming Information
Configuration Digit Number Description
Default
Number
NOTE: Machine configuration must be completed before any personality settings can be changed. Changing personality set-
tings first and then changing the model number of the machine configuration will cause personality settings to return to
default
MODEL NUMBER:
1 6 600SC 1
MARKET:
2 0
1
2
3
4
5 ANSI USA
ANSI EXPORT
CSA
CE
AUSTRALIA
JAPAN 0
ENGINE:
3 12
16 DEUTZ ECM: Deutz Engine Control Module (Tier 2 and 3)
DEUTZ ECM T4F: Deutz Engine Control Module (Tier 4 Final) 14
GLOW PLUG:
5 0
1
2 NO GLOW PLUGS: No glow plugs installed.
AIR INTAKE: Glow plugs installed in the air intake on the manifold.
IN-CYLINDER: Glow plugs installed in each cylinder. 2
STARTER LOCKOUT:
6 0
1
DISABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start can be attempted at any time during pre-glow.
ENABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start is NOT permitted until pre-glow is finished.
0
FUEL CUTOUT:
7 0
1
2
RESTART: Engine allowed to be restarted multiple times when very low
fuel level is reached.
ONE RESTART: Engine allowed to be restarted once for 2 minutes when very
low fuel level is reached.
ENGINE STOP: Engine not able to restart when very low fuel level is reached.
0
*This menu item is only visible if non dual fuel engines are selected.
ENGINE SHUT-
DOWN:
8 0
1
DISABLED: No engine shutdown.
ENABLED: Shutdown engine when coolant temperature is greater than
110°C or oil pressure is less than 8 PSI.
1