Sample only, Sample only - use chart in cab – JLG G6-42A Operator Manual User Manual

Page 15

Form No. 20036 • G6-42A Owner/Operator Manual

24"

406 MILL AVE. S.W., NEW PHILADELPHIA, OHIO 44663

GRADALL IS A REGISTERED TRADEMARK FOR

HYDRAULIC EQUIPMENT BUILT BY THE

GRADALL CO. MANUFACTURED IN THE U.S.A.

AS RELEASED FROM FACTORY THIS TRUCK MEETS THE DESIGN SPECIFICATIONS

ESTABLISHED IN AMERICAN NATIONAL STANDARDS FOR POWERED INDUSTRIAL

TRUCKS PART III ASME B56.6b-1998.

CAP#

X1000

A
B

42'

6.6

1.0

CAPACITY WITH STANDARD

48" & 72" CARRIAGE.

(WITHOUT

ATTACHMENTS)

4.6'

20,650

20,460

24"

42'

24"

C
D

ATTACHMENT

TRUCK &

ATTACHMENT

WEIGHT

24"

6.6

20,180

CAP#

1000

9147-3131 (B)

42'

24"

6.6

20,290

6.6

42'

24"

42'

6.6

48" CARRIAGE

P/N 9140-5073 *
72" CARRIAGE

P/N 9140-5074 *

SHIPPED

WITH

48" SLOPE PILER

P/N 9140-5101 *
72" SLOPE PILER

P/N 9140-5079 *

2.0'

26.9'

2.0'

2.7'

FORKS RATED LESS THAN THE ATTACHMENT CAPACITY SHOWN ABOVE DECREASE

CAPACITY OF ATTACHMENT TO THAT OF FORKS. FORKS RATED MORE THAN

ATTACHMENT CAPACITY DO NOT INCREASE ATTACHMENT CAPACITY.

*WEIGHTS ARE BASED ON USING 2 X 4 X 48" FORKS (APPROX. 268# PER PAIR)

**BUCKET DIMENSIONS (A & D) REFER TO BUCKET LIP HEIGHT.

***TRUSS BOOM & WINCH DIMENSIONS (A & D) REFER TO HOOK CENTER.

****WEIGHT IS BASED ON SP'L SWING MAST FORKS (APPROX. 230# PER PAIR)

*****PLATFORM DIMENSIONS (A & D) REFER TO CENTER OF FLOOR.

19430 LBS

SAMPLE ONLY - USE CHART IN CAB

2.3

Located on right cab wall

P/N 9147-3131

Located on right cab wall

P/N 9147-3217

Located on left side, front cab plate

P/N 9116-4094

000850

THE PROTECTION OFFERED BY THIS

ROPS WILL BE IMPAIRED IF IT HAS BEEN

SUBJECTED TO ANY MODIFICATION,

STRUCTURAL DAMAGE, OR HAS BEEN

INVOLVED IN AN OVERTURN INCIDENT.

THIS ROPS MUST BE REPLACED AFTER

A ROLL-OVER. SEAT BELTS MUST BE

WORN WHILE OPERATING VEHICLE.

GRADALL MATER

06 / 9 / 10

MAX WEIGHT : 2150
MEETS SAE : J1040 MA

MEETS ISO : 3471 (94) / 3
MEETS ANSI : B56.6 - 8.16 / P

GRADALL : 9114-3261 SERIAL : 8

Box 61

SD 57201

SAMPLE ONLY

Located on back wall, behind

operator’s seat

P/N 9147-4483 (enclosed cab)

P/N 9147-4471 (open cab)

9114-3290

ATTACHMENT MUST BE SECURED TO MACHINE.

CHECK TO ASSURE QUICK SWITCH PLUNGER

PIN IS FULLY ENGAGED AND LOCKED AFTER

ATTACHMENT CHANGE.

IF PLUNGER PIN IS NOT FULLY ENGAGED

AND LOCKED ATTACHMENT MAY FALL OFF

CAUSING SERIOUS INJURY OR DEATH.

Located on boom head

P/N 9114-3290

Diesel Engine

SERVICE INTERVALS

LUBRICATION AND MAINTENANCE

MATERIAL HANDLER

9147-3217 REV(-)

Use this chart in conjunction with the "Lubrication & Maintenance" and "Recommended

Lubricants & Capacities" sections of the Owner/Operator Manual.
Service intervals may need to be more frequent than those shown depending upon

application severity. Consult your Gradall dealer for recommendations.
It is recommended that engine oil and filter, transmission lubricant and filter,

transfer case lubricant and axle lubricant be changed after first 100 hours on

new, or rebuilt units.

LUBRICANT TYPE

SPECIFICATION

Air Cleaner Element
Fuel Filter
Engine Oil Filter
Engine Oil
Coolant
Diesel Fuel

YEARLY

1500 HRS

6 MO.

1000 HRS

3 MO.

500 HRS

EVERY 5

WKS OR

250 HRS

WEEKLY

50 HRS

DAILY

10 HRS

Transmission

Lubricant
Filter

Transfer Case

Lubricant

Center Section

Axle Lubricant

Planetary Hubs

Filter

Lubricant

Hydraulic System

Breather/Filter

Grease Fittings

Axles (6 Pts. Ea.)
Boom Head Pivot (2 Pts.)
Boom Pivot (2 Pts.)

Extend Chain Sheave (1 Pt.)

Drive Shafts (1 Pt. Ea.)

Cylinder Pins(13 Pts.)

Quick Switch Pin (1 Pt.)
Retract Chain Sheave (1 Pt.)

Boom

Front Bottom Bearing Pads
All Other Bearing Pads
Extend/Retract Chains

Options And Attachments

Stabilizer Cylinder (3 Pts.)
Attachment Pivots And Pins

Tires

13.00-24 12 Ply
13.00R24 Radial
15.5-25 12 Ply

Lug Nut Torque

Torque

Check

Check
Check

Check

Check
Check

Check

Grease

Grease
Grease

Grease

Change

Change
Change

Change

Change
Change

Change
Change
Change

SAE 15W-40 CH/CI Oil

Ethylene Glycol

No. 2 Diesel Fuel

Mobil 424

Mobil 424
Mobil 424

Mobil 424

Mystik Tetrimoly
Mystik Tetrimoly
Mystik Tetrimoly
Mystik Tetrimoly
Mystik Tetrimoly
Mystik Tetrimoly
Mystik Tetrimoly
Mystik Tetrimoly

Mystik Tetrimoly
Mystik Tetrimoly

See Manual

65 PSI (448 kPa)
70 PSI (483 kPa)
58 PSI (400 kPa)

350-400 Lb-Ft (475-540 Nm)

Fill

SAMPLE ONLY - USE CHART IN CAB

Located on dash

Starting S/N 0160001283

P/N 9141-3061