JLG LiftPOD FS80 (1001070465) User Manual
Page 89
SECTION 7 - TROUBLESHOOTING
LIFTPOD by JLG
1001070465
www.liftpod.com
7-3
Platform will not move when in elevated position - motor starts
Driveshaft interlock is engaged
Push cordless drill on driveshaft down firmly to disengage driveshaft safety inter-
lock.
(If using powerpack) Powerpack shaft not
engaged
Check powerpack charged and in correctly fitted and is fully down and latched
down.
Drive shaft malfunction
Lower platform using manual descent procedure (see Section 4.1). Refer to
Authorized JLG Service Center.
No load in platform & will not lower
If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. If carriage is within 1m (3ft) from ground, apply load in platform,
drive up 1", then drive down.
Ropes are loose (ropes must never be loose)
Machine was disassembled without platform
being fully lowered to engage the carriage lock
down latch. Carriage then moved up the mast
loosening the ropes
If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. Otherwise follow rope re-tensioning procedure detailed in Section
6.7, point 3. Ensure both ropes are tight and remain so at all times.
TROUBLE
PROBABLE CAUSE
REMEDY