JLG DVSP Series Operator Manual - Manual (Page 40)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-20 – JLG Lift – 3121135
StockPicking Platform Operation
The stockpicking platform is available in two (2) versions.
• Fixed side-rail version
• Folding side-rail version
CAUTION
THE STOCKPICKER PLATFORM ALLOWS THE MACHINE TO BE
OPERATED IN AN OPEN RAIL CONFIGURATION (SEE ILLUSTRA-
TION).
CE SPECIFICATION MACHINES:
T H E O P E R A T O R M U S T W E A R A F U L L B O D Y H A R N E S S
EQUIPPED WITH A LANYARD SHORT ENOUGH TO PREVENT A
F A L L F R O M T H E P L A T F O R M . T H E L A N Y A R D M U S T B E
ATTACHED TO THE AUTHROIZED LANYARD POINT. ALSO, JLG
RECOMMENDS THAT CE SPECIFICATION MACHINES EQUIPPED
WITH THE STOCKPICKER PLATFORM ARE ONLY TO BE USED
FOR STOCKPICKING APPLICATIONS.
NON-CE UNITS:
THE OPERATOR MUST WEAR A FULL BODY HARNESS WITH A
LANYARD (MAX. 6 FT. (1M) ATTACHED TO THE AUTHORIZED
LANYARD POINT OR A BODY BELT EQUIPPED WITH A LANYARD
SHORT ENOUGH TO PREVENT A FALL FROM THE PLATFORM.
WHILE OPERATING THE MACHINE IN THE OPEN RAIL CONFIGU-
RATION, ALWAYS OPERATE THE MACHINE FROM THE REAR OF
THE PLATFORM WITH THE MID-GATE CLOSED AND THE PLAT-
FORM CONTROL CONSOLE ATTACHED TO THE FIXED PORTION
OF THE GUARDRAIL.
STOCKPICKER PLATFORM
(WITH FOLDING SIDE-RAILS) (DVSP)
Model Max. Capacity
15DVSP 500 lb. (230 kg)
20DVSP 400 lb. (180 kg)
1. Primary Entrance/Exit Gate 4. Platform Control Console
2. Primary Entrance Latch 5. Mid-Gate
3. Lanyard Attach Point - 6. Gate Release/Lock Pins
(on side of mast) 7. Secondary Exit Gate
6
6
2
1
3
4
5
7
STOCKPICKER PLATFORM
(OPEN RAIL CONFIGURATION) (DVSP)
1. Platform Mid-Gate (enter rear of platform and close mid-gate
when driving with front rails open).
2. Open Rail Configuration work area. (See previous Caution about
fall protection requirements).
3. Platform Control Console attached to fixed side-rail in the rear of
the platform.
1
3
2