JLG DVSP Series Operator Manual - Manual (Page 29)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121135 – JLG Lift – 3-9
• Enable Detection of Beacon Open Circuit -
Enables mast/base beacon strobe electrical circuits
to be turned on (YES) or off (NO) if machine is
equipped with either or both beacon strobes.
• Forward Alarm Disable - When turned on (YES) will
disable the alarm when driving forward.
• OSS Diagnostics - When turned on (YES) will cause
the controller LCD to continuously display the
Obstruction Sensing System (OSS) Diagnostics until
turned back off (NO).......the machine will function
normally, but only the OSS Diagnostics screen will
display until this setting is re-set to the off (NO) posi-
tion.
Activating Programming Mode
NOTE: If machine does not power up, check that both the
Ground Control Station - Emergency Stop Button,
and the Platform Control Console - Emergency Stop
Button, are in the RESET position.
Also if machine is equipped with the (PSL) Program-
mable Security Lock option, see Section 3.5 of this
Operators Manual for additional machine power-up
steps.
Entering Password
Programming Mode Selection
1. With machine power OFF, press and hold the Brake
Release Button (1) on the Ground Control Station.
2. While holding the Brake Release Button in, power
machine up by turning the Main Power Selector
Switch (2), to either the Ground Control or Platform
Control Mode.
3. Release the Brake Release Button (1) after machine is
powered up. The LCD display should now display five
zeros, one with a box around. Continue to next step
Entering Password.
1
2
1. The Brake Release button (1) moves the box from left
to right to select which digit to change.
2. Platform UP button (2) increases the numerical digit.
3. Platform DOWN button (3) decreases the numerical
digit.
4. Change all five digits (4) to match password level,
then press the Brake Release button (1) again.
1. Use Platform UP/DOWN buttons (1) to move the
selection box (2) up or down to select item to pro-
gram.
2. Press the Brake Release button (3) to enter selected
mode then move on to Selecting Programmable Item
to Adjust.
1 2 3
00000
4
1
2
3