JLG DVSP Series Operator Manual - Manual (Page 26)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-6 – JLG Lift – 3121135
Machine Status LCD Display
At power-up and during operation the LCD display on the
Ground Control Module displays the current machine
operating status. The following illustration explains the
symbol indications.
In the LCD Display Symbols illustration item (2), the Func-
tion Display or Function Disabled Indicators will vary as
shown following:
LCD Display Fault Conditions
Table 3-3, LCD Display - Operating Fault Conditions show
common LCD display Fault indications which may occur
during operation and are usually caused by either an error
in machine operation or a work area condition. These
fault conditions can usually be corrected by the operator
and do not require a qualified mechanic to repair.
IMPORTANT
AFTER A FAULT CONDITION IS CORRECTED THE MACHINE
POWER MAY NEED TO BE RECYCLED TO RESET THE GROUND
CONTROL STATION.
LCD Display Symbols
1. Battery Charge Indicator (BCI)
2. Function Display or Function Disabled Indicators
3. Hour Meter Display
4. Fault Code Indicator
5. Fault Text Message Display (a)
Note: (a) When an Fault Code is indicated the LCD screen will
alternate between the text and symbol display modes.
3
5
4
1 2
00
00
00000.0
DRIVE Disabled
LIFT UP Disabled
LIFT DOWN Disabled
Both LIFT UP and LIFT DOWN
Disabled
Drive Speed Cut-Back (Turtle) Mode
Engaged (When Platform is Elevated)
Battery Charger (AC) Plugged In