JLG 3246ES Parts Manual User Manual
Page 10
1-4
1930ES, 2030ES 2630ES, 2646ES & 3246ES
SECTION 1 FRAME
102(cont’d)
Ref.
2030ES/2630ES/2646ES/3246ES
No Longer
Available - See
Note
USA Built Machines Prior to S/N 0200118041 & Belgium
Built Machines Prior to S/N 1200001487
(was p/n 0272306) (See Figure 1-2 for Breakdown)
NOTE: To replace the complete unit both right & left Drive
Assemblies must be upgraded at the same time. Order
qty 2 of p/n 1001100975.
Use 1001100975
USA Built Machines S/N 0200118041 to S/N 0200135154
& Belgium Built Machines S/N 1200001487 to
S/N 1200004293 (See Figure 1-3 for Breakdown)
(was p/n 3160307)
102A
3577112
2
Plate, Spacer (Used only on Machines with Kit
p/n 2915236 installed)
103
4
Wheel & Bolt Kit Options (includes Item 104):
Ref.
Note: Must replace Tire & Wheel Assemblies in pairs per
axle.
2915012
1930ES (was p/n 0272699, 2915005, 4520277, 4520326 &
4520565)
2915013
2030ES/2630ES/2646ES/3246ES
(was p/n 2915006, 4520278, 4520327 & 4520676)
104
20
Bolt, Wheel Options:
0630579
36mm Length
0630580
22mm Length
105 to 107
Not Used
108
2780266
2
Hub Assembly (See Items 201-208 for Breakdown)
109 to 111
Not Used
112
3760463
2
Ring, Retaining
113
Not Used
114
4740523
4
Washer, Spindle Retaining
115
4740524
2
Thrustwasher M60
2780266
Ref.
HUB ASSEMBLY
B
Ref.
Note: Qtys shown for 1 Assembly. Two Assemblies required
per machine.
201
Use 1001102354
1
Cap, Dust (was p/n 7012524)
202
Use 3300423
1
Nut, Slotted (was p/n 7010641)
203
Use 3450406
1
Pin, Cotter 2” x 3/16” (was p/n 7010642)
204
Use 4740468
1
Washer (was p/n 7019697)
205
Use 1001102351
1
Bearing, Cone - Outer (was p/n 7026185)
206
Not Available
1
Hub (Purchase Complete Hub p/n 2780266)
207
Use 1001102353
1
Bearing, Cone - Inner (was p/n 7026183)
208
Use 1001102349
1
Seal (was p/n 7026184)
Ref.
FRAME WELDMENTS
301
A/R
Bushing Options:
0440264
2
1930ES
0440265
4
2030ES/2630ES/2646ES/3246ES
302
A/R
Kingpin Rework Instruction Options (Provides rework procedure
for damaged kingpins):
3128601
1930ES/2030ES/2630ES
3128703
2646ES/3246ES
FIGURE 1-1. STEERING, DRIVE AND REAR AXLE INSTALLATIONS (CONTINUED)
ITEM #
PART NUMBER
QTY.
DESCRIPTION
REV.