Eppendorf C-76 Classic Water Bath Shaker - Manual (Page 33)

33
New Brunswick Operating manual
8. Using your fingers, reach under the SUBPLATFORM and move the belt so that it falls
off the drive pulley. Remove the belt from the bearing housing pulley.
Figure 15: Belt Removal
9. Grab the belt from underneath the SUBPLATFORM , pull it forward and over one
corner of the SUBPLATFORM . Repeat for the other corner, until the belt clears the
SUBPLATFORM , but is constrained by the LOWER MOVER PLATE .
10. Slide the belt to one of the unattached sides of the LOWER MOVER PLATE and pull it
through the opening.
11. Slide the belt to the other side of the LOWER MOVER PLATE , pull it through the
opening, and remove it from the unit.
12. Install the replacement belt in similar fashion.
13. Reattach the UPPER FLEXURES to the LOWER MOVER PLATE .
BEARING
HOUSING
PULLEY
DRIVE
PULLEY
BELT
LOWER
MOVER
PLATE