6 operation, 1 starting the c-76, 2 continuous (unlimited) run – Eppendorf C-76 Classic Water Bath Shaker User Manual
Page 24: 3 checking any setpoint, 6o o
24
M1248-0051
C-76 Classic Water Bath Shaker
Operating manual
6
6
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
6.1
Starting the C-76
To initially start the shaker, turn the
ON/OFF SWITCH
on the side of shaker to the
ON
position. If the Shaker begins to operate, the
LED DISPLAY
will track the speed as it
accelerates to the last entered setpoint. The shaking action may be stopped or started by
pressing the
START/STOP KEY
.
6.2
Continuous (Unlimited) Run
1. Press
SELECT
until the
RPM INDICATOR
is illuminated.
2. If the display indicates that the shaker is
OFF
, press the
START/STOP KEY
.
3. Press either
σ or
τ KEY
to enter
SET MODE
(the
SET INDICATOR
will illuminate).
4. Set the speed by using the
σ or
τ KEY
until the desired setpoint is displayed. Holding
the
σ or
τ KEY
will cause the setting to change more rapidly.
NOTE:
The setpoint may be changed during a run without stopping the shaker by
following steps 2-4 above. During speed changes, a visual alarm (flashing
RPM INDICATOR
) will flash until the speed returns to within 5 rpm of the
setpoint.
6.3
Checking Any Setpoint
1. Press
SELECT
until the desired indicator is illuminated.
2. Press either
σ or
τ KEY
to enter the
SET MODE
and display the current setpoint.