4 timed functions, 1 setting the timer, 2 cancelling the timer – Eppendorf C-76 Classic Water Bath Shaker User Manual

Page 25: Caution

New Brunswick

Operating manual

6.4

Timed Functions

The shaker can be programmed to stop automatically after a preset time period of 0.1
hour to 99.9 hours. There must be power to the shaker in order to set the timer; however,
a timed run can be initiated while the unit is either shaking or stopped.

6.4.1 Setting the Timer

To set the time:

1. Press the

SELECT KEY

until the

HRS INDICATOR

is illuminated.

2. Press either

σ or

τ KEY

to enter the

SET MODE

and set between 0.1 - 99.9

hours.

3. While the

SET INDICATOR

is illuminated, press the

START/STOP KEY

program the time (and start the run). The

TIME INDICATOR

will light and

remain on for the duration of the run. At the end of the timed run, the display
will read

OFF

, and the

TIME INDICATOR

will flash.

1. To disable the alarm (flashing

TIME INDICATOR

), press the

SELECT KEY

and

change to any other function.

6.4.2 Cancelling the Timer

To cancel the timer without stopping the shaker:

1. Press the

SELECT KEY

until the

HRS INDICATOR

is illuminated.

2. Press either

σ or

τ KEY

to enter the

SET MODE

and set between 0.1 - 99.9

hours, then immediately press the

START/STOP KEY

. The

TIME INDICATOR

will cease to flash and the display will read

OFF

CAUTION!

Holding the

σ or τ key for more than 0.5 seconds will cause

the speed setpoint to change. Should this occur, resetting
will be necessary.