Eppendorf 5000 Digital Tier Shake - Manual (Page 20)

20
New Brunswick Operating Manual
3.4 Timed Functions
The shaker may be programmed to stop automatically after a preset time period of 0.1
hour to 99.9 hours. There must be power to the shaker in order to set the timer.
However, a timed run can be initiated while the unit is either shaking or stopped.
3.4.1 Setting the Timer
1. Press the SELECT key to light HRS.
2. Press either
σ or τ to enter the Set mode, then set a time period of 0.1 to
99.9 hours.
3. While Set light is lit, press the START/STOP key to program the time (and
start the run).
The Time indicator will light and remain on for the duration of the run. At the
end of the timed run the display will read
OFF , the time indicator will flash and
the audible alarm will sound.
The setpoint may be changed during a run without stopping the shaker by
following steps 1 and 2 above.
3.4.2 Cancelling the Timer
To cancel the timer without stopping the shaker:
1. Press the
SELECT key to light HRS.
2. Press either
σ or τ to enter the Set mode, then set a time period of 0.1 to
99.9 hours.
3. Immediately press the START/STOP key. The time indicator will go out
and the display will read OFF .
3.4.3 Total Running Time
Innova shakers’ control modules continuously monitor the total running time
the shaker has been
ON , to track hours of usage.
To display the accumulated running time:
1. Select HRS using the
SELECT key.
2. Simultaneously press the
σ and τ keys.