Eppendorf 5000 Digital Tier Shake - Manual (Page 13)

13
Innova 5000  M1196-0050 Operating Manual
2 2 I I
N N S S T T A A L L L L A A T T I I O O N N
2.1 Unpacking
Upon unpacking the unit, inspect it carefully for any apparent damage that may have
occurred during transit. Immediately report any damage to the carrier and to the New
Brunswick Scientific Co., Inc. Service Department.
Do not discard the crate or packing material.
2.2 Voltage Configuration
Determine the voltage of your unit by checking the voltage indicator and Caution label
on the rear of the unit. Confirm that the correct electrical service package is included
with the unit by referring to the table below (also see Section 5.2, Changing Voltage &
Frequency).
Voltage Configuration Table
Innova 5000 Catalog Number Electrical Service Package
M1196-0001 100V 50/60Hz (M1196-0070)
M1196-0000 120V 50/60Hz (M1196-0070)
M1196-0002 220V 50/60Hz (M1196-0071)
M1196-0003 240V 50/60Hz (M1196-0071)

NOTE:
Use of the Innova shakers requires a platform which is separate item.
See Section 6 of this manual for a listing of available platforms. The
Innova 5000 uses 32½-inch x 26¾-inch (82.5 cm x 68 cm) platforms.
2.3 Space Requirements
It is essential that the instrument be situated in an area where there is sufficient space
for the shaker and platform to clear walls and obstructions during operation. See
Figure 3 on the following page.
WARNING!
Do not plug the shaker into a power source until you check
the voltage setting.