Aerovent IM-167 - Manual (Page 10)

10 Aerovent IM-167
Side Discharge Option
Side discharge kits (including panels, mounting collars,
and necessary hardware) are available to provide 1-way,
2-way, or 3-way discharges. Note: Panel opposite motor
(on belted BSI) cannot be used for discharge.
INLET INLET
INLET
LEFT
RIGHT
LEFT
RIGHT
INLET
LEFT
REAR
REAR
RIGHT RIGHT
INLET
REAR
LEFT
FIG. B
FIG. G
FIG. E
FIG. F
FIG. C
FIG. D
INLET
Option Figure Configuration
Standard A Rear
1-Way
B Left
C Right
2-Way
D Left and Right
E Left and Rear
F Right and Rear
3-Way G Left, Right and Rear
Configurations
INLET
REAR
Fig. A
Duct Openings
Model
SCBD
Model
SCDD
Left and Right Discharge Rear Discharge/Inlet
Duct Collar Duct Size
Required
Duct Collar Duct Size
Required Width Height Width Height
080 080 11.88 11.88 12 x 12 11.88 11.88 12 x 12
090 090 11.88 11.88 12 x 12 11.88 11.88 12 x 12
100 100 13.88 13.88 14 x 14 13.88 13.88 14 x 14
120 120 15.88 15.88 16 x 16 15.88 15.88 16 x 16
135 135 17.88 17.88 18 x 18 17.88 17.88 18 x 18
150 150 19.88 19.88 20 x 20 19.88 19.88 20 x 20
165 165 22.88 22.88 23 x 23 22.88 22.88 23 x 23
180 — 23.88 23.88 24 x 24 23.88 23.88 24 x 24
210 — 27.88 27.88 28 x 28 27.88 27.88 28 x 28
225 — 25.88 28.88 26 x 29 29.88 29.88 30 x 30
245 — 27.88 31.88 28 x 32 32.88 32.88 33 x 33
270 — 29.88 33.88 30 x 34 35.88 35.88 36 x 36
300 — 29.88 37.88 30 x 38 39.88 39.88 40 x 40
330 — 31.88 39.88 32 x 40 43.88 43.88 44 x 44
365 — 32.88 41.88 33 x 42 45.88 45.88 46 x 46
402 — 34.88 46.88 35 x 47 51.88 51.88 52 x 52
Side Discharge Instructions
SCREW, WHIZLOCK
SELF THREAD
#10 X 1/2 LG
OUTLET ANGLE
1/4-20 X 3/4
TAPTITE SCREW
ACCESS PANEL
NOTES:
1. Remove outlet angles from fan discharge.
2. Remove access panel from side required to be discharge.
3. Mount outlet angles on new discharge.
4. Mount access panel on back of fan (previous outlet).