Snorkel XT24SD-sn000001+ - Manual (Page 23)

1/31/2008 - 27 -
green indicator light for variable height the switch will be off, the alarm light will
be lit and the alarm horn will sound. In this state the operator will not be able to
lift the platform.
LOW VOLTAGE ALARM
If the battery has a low charge, the low battery light will be lit and the machine
will not operate. The batteries must be charged before continuing operation of the
lift.
DO NOT OPERATE THE MACHINE WITH
LOW CHARGE ON THE BATTERIES.REFER TO
BATTERY AND CHARGER SECTION (PAGE 28).
MAINTENANCE
HYDRAULIC FLUID LEVEL/TYPE AND MAINTENANCE
Use ATF Mercon/Dexron-III fluid to refill unit
Check snap rings on scissors sections before each use. Replace any missing,
broken or loose nuts and bolts
Check and refill hydraulic fluid before each use. Fluid level should be 5 cm
below top of fill tube.
Check the tire pressure, hydraulic hose and electrical wires for abrasions and
cuts before each use. Replace damaged items.
Inspect outriggers and pins for damage and cracks before each use and once a
year check and grease wheel bearings
ROUTINE MAINTENANCE MANUAL
 Inspect machine for any metal fatigue or wear.
Do not use if any cracked welds are found. Cease operation and contact PLE,
Inc. if any defects are found. Refer to PLE pre-delivery and inspection
report for additional information
 Check t-handles connections on outriggers
The outrigger t-handles are to be tested on each outrigger.
Battery Charging Plug