beautypg.com

Warning, Chapter 4 – safety devices – Snorkel TB66J CE User Manual

Page 19

background image

TB60/66J – 0084030EE

5

This aerial work platform is manufactured with safety

devices, placards, and decals to reduce the likelihood of

an accident. For the safety of all personnel, do not dis-

able, modify or ignore any safety device. Safety devices

are included in the daily prestart inspection.

A

Warning

The potential for an accident increases when safety

devices do not function properly. Death or serious

injury can result from such accidents. Do not alter,

disable, or override any safety device.

If any safety devices are defective, remove the aerial

platform from service until qualified maintenance person-

nel can make repairs.

Emergency Stop Controls

There is an emergency stop control at the lower and

upper controls.

At the lower controls, the emergency stop is a two-posi-

tion push button (refer to Figure 4.). Push the emer-

gency stop button in to disconnect power to all control

circuits. Pull the button out to restore power.

Figure 4.1 – Lower Controls

Note

The lower controls override the upper controls. If the

upper control emergency stop button is engaged, the

lower controls can still be used to operate the aerial

platform.

At the upper controls, the emergency stop is a two-posi-

tion push button (refer to Figure 4.2).

Figure 4.2 – Upper Controls

Push the emergency stop button in to disconnect power

to the upper control circuits. Pull the button out to restore

power.

Emergency Power System

The emergency power system includes a back-up

pump, motor, and battery. Use this system to operate

the boom and turntable functions to lower the platform

if the main power system fails due to engine or pump

failure. Hold the engine/emergency power switch (refer

to Figure 4. and 4.2) down to activate the emergency

power system.

The length of time the pump can be operated depends

on the capacity of the battery.

Emergency Lowering Knob

The emergency lowering knob may be used to lower

the booms if the engine will not start and the emergency

power system will not work. The knob is on the base

end of the main boom lift cylinder (refer to Figure 4.3)

under the left side of the turntable.

Figure 4.3 – Emergency Lowering Knob

Chapter 4 – Safety Devices

Emergency

Lowering Knob

Emergency

Stop Button

Ground Operation

Switch

Engine/Emergency

Power Switch

Emergency

Stop Button

Engine/Emergency

Power Switch

This manual is related to the following products: