Snorkel TB126J - Manual (Page 57)

10. DAILY INSPECTION & MAINTENANCE
10 - 1 P/N 0191915
10. DAILY INSPECTION
& MAINTENANCE
At the start of each work day (or 8 hour shift) a
TB126J qualified operator must perform the
DAILY INSPECTION AND MAINTENANCE listed
in the table below.
The purpose of the daily inspection and
maintenance is to keep the TB126J in proper
working condition and to detect signs of
malfunction at the earliest possible time.
D A N G ER
Do not operate a TB126J that is
known to be damaged or
malfunctioning. Defective parts or
equipment malfunctions jeopardize
the safety of the operator and other
personnel, and can cause damage to
the machine.
DAILY INSPECTION AND MAINTENANCE TABLE
(Set the MASTER KEY SWITCH to OFF before you begin this inspection)
ITEM SERVICE REQUIRED
1. Engine fuel level Check fuel gauge (full)
2. Fuel tank cap Visually inspect (installation)
3. Engine oil Check oil level (between dipstick lines)
4. Fuel leaks Visually inspect (hoses, connections, etc.)
5. Engine coolant Check fluid level and radiator hoses
6. Wiring harnesses Visually inspect (installation, condition)
7. Battery terminals Visually inspect (no corrosion)
8. Battery fluid level Check fluid level (in contact with filler neck)
9. Hydraulic oil Check fluid level (between lines on gauge)
10. Hydraulic oil leaks Visually inspect (hoses, tubes)
11. Tires and wheels Visually inspect (condition)
12. Bolts and fasteners Visually inspect (looseness)
13. Structural damage & welds Visually inspect (weld cracks, dents)
14. Platform gravity gate Visually inspect (operation)
15. Axle/boom interlock Check operation
16. Emergency power motor/pump Check operation (causes correct motion)
17. Air filter Check condition (gauge)
18. Charging system Visually inspect (gauge)
19. Control switches Actuate and visually inspect for operation
20. Slide pads Visually inspect (boom wear marks)
21. Whiffles and wire ropes Visually inspect (even tension, condition)
22. Envelope management system Check operation
23. Placards and decals Visually inspect (installation, condition)