beautypg.com

Operating the auto level system 8-9, Setting the stabilisers automatically 8-9, Raising the stabilisers automatically 8-9 – Snorkel SR3370 User Manual

Page 55: Extending the multi-position platform 8-9, Extending the platform, 8-9, Auto operation, 8-9, Operating the auto level system -9, Extending the multi-position platform -9, Warning, Operation

background image

n Operating The Auto Level System

q

Setting the stabilisers automatically

1. The engine must be running and the SR set

for platform control box operation.

Figure 8.25

2. Press and hold the switch • down to the

‘Auto Level’ position until all movement
stops or the Lift Enable Light

illuminates.The SR will attempt to
automatically level itself.

3. The Lift Enable Light € will illuminate if all 4

feet are in contact with the ground and the
machine is level.

4. If a stabiliser foot will not go down sufficiently

to make contact with the ground it is possible
that the cylinder has reached the end of its
stroke. Retract all stabilisers and put suitable
dunnage under the feet that did not touch the
ground and repeat step (2).

NOTE:

Manual or auto levelling is possible any time that
stabiliser movement is allowed. For example, the
machine can be manually levelled part way and
then auto levelled without the necessity of
retracting the stabilisers between the two
operations.

q

Raising the stabilisers automatically

1. Completely lower the platform.

2. Press and hold the switch • up to the ‘Auto

Stow’ position. The stabilisers will raise to the
stowed position.

n Extending The Multi-Position Platform

Figure 8.26

The MULTI-po si tion ex tend ible plat form (see Fig -
ure 8.26) can be se curely locked into dif fer ent po si -
tions. To move it from one po si tion to the other do
the following:

1. Stand on the non-extendible part of the

platform and face the front of the machine.

The distribution of the RATED WORK LOAD
changes when the extendible platform is
extended. Read the decal on the toe board at
the front of the platform or at the entrance to the
platform for safe weight distribution.

2. Lift up the deck extension handles (one for

each side of the deck)

• to unlock the deck

(see Figure 8.26).

3. Push or pull the deck extension handles to

move the platform to the desired position.

4. Lower the deck extension handles and allow

the lock

€ to locate (see Figure 8.26).

SR3370 & SR2770 – 12696A

Rev B

page 8 - 9

8. Operation

WARNING

EXTENDABLE

PLATFORM

NON-EXTENDABLE

PLATFORM

This manual is related to the following products: