Snorkel SR3370 - Manual (Page 37)

n Engine Oil
Figure 7.6 - Engine Oil Level
Keep the oil level be tween the marks on the dip -
stick
• (see Fig ure 7.6).
The dis tance be tween the top and bot tom dip stick
marks cor re sponds to about 1 qt. (one li ter). Add
oil, if needed at the cap
€ (see Fig ure 7.6), there is
an al ter na tive filler cap on top of the en gine.
See the Spec i fi ca tions chap ter for the cor rect en -
gine oil grade and weight.
n Engine Coolant
Figure 7.7 - Engine Coolant Level
The Kubota en gine is liq uid cooled. At op er at ing
tem per a tures the cool ant should be at the HOT
level • (see Fig ure 7.7). When cold there should be
ap prox i mately 1 inch (2.5 cm) of cool ant in the bot -
tom of the res er voir.
The cool ant is half wa ter and half eth yl ene gly col.
To add cool ant:
Turn the engine OFF at the ground control box box
KEY SWITCH. Remove the cap
€ (see Figure 7.7)
from the coolant reservoir. Add coolant and replace
cap.
n Radiator Cap
Figure 7.8 - Radiator Cap
Vi su ally check to see that the cap is in place and
tight.
n Swinging Gate
Figure 7.9 - Swinging Gate
In spect the gate to see that it swings freely, latches
se curely, and is not de formed in any way.
n Wiring Harnesses and Connectors
In spect all the wir ing har nesses, on the ma chine,
for loose con nec tions, bro ken wires, and frayed in -
su la tion.
Figure 7.10 - Wiring Harnesses and Connectors
SR3370 & SR2770 – 12696A Rev B page 7 - 3
7. Daily Inspection and Maintenance