Snorkel SR3370 - Manual (Page 52)

Figure 8.17
6. Turn the Emergency Stop switch …
clockwise and it will pop out (on) (see Figure
8.17).
7. If the engine is at ambient temperature,
momentarily press the GLOW-PLUG switch
†. This action will automatically turn the
glow-plugs, in the engine, on for 10 seconds.
A light
‡ will automatically come on to
indicate that the glow-plugs are on (see
Figure 8.17).
8. When the light ‡ goes out, press and hold
the START switch •~ until the engine starts
or for 20 seconds, whichever comes first.
When the engine starts, release the START
switch
•~ (see Figure 8.17).
If the engine does not start in 20 seconds,
release the START switch
•~ then wait 60
seconds before trying to start the engine again
with the GLOW-PLUG
† and START switches
•~.
n Driving
1. The engine should be running. If not, start it
from the platform control box as described
previously.
Figure 8.18
2. Set the Speed switch • to turtle (slow) (see
Figure 8.18) if you are going to be driving
close to other objects or need to move the
SR very slowly for other reasons.
NOTE
Setting the SPEED to rabbit doubles the travel
speed. (See the Specifications chapter for
speeds of different models.)
3. Set the Lift/Drive Selector switch € to drive
(right) (see Figure 8.18).
The SR is about to move. If you have to make an
emergency stop, release the Joystick Controller
• and sharply strike the Emergency Stop switch ‚
straight in.
To make a normal stop, slowly move the
Joystick Controller
• to its centered neutral
position then release it.
4. Squeeze and hold the Safety Control ƒ
against the Joystick Controller • (see Figure
8.18).
5. Push the Joystick Controller • (see Figure
8.18) slowly forward or pull it slowly
backward, depending on which way you want
to go. The further you move the joystick the
faster the SR moves.
6. To make a right or left turn, press and hold
the Steering rocker-switch „ on top of the
Joystick Controller • (see Figure 8.18).
page 8 - 6 Rev B SR3370 & SR2770 – 12696A
8. Operation
CAUTION
WARNING