Snorkel SP18 - Manual (Page 16)

The use and operation of the aerial work platform
as a lifting tool or crane (lifting of loads from below
upwards or from a height to the ground) is
prohibited!
NEVER exceed the manual force allowed for this
machine. See Special Limitations on page of this
chapter for details.
DISTRIBUTE all platform loads evenly on the
platform.
NEVER operate the machine without first
surveying the work area for surface hazards such
as holes, drop-offs bumps, curbs, or debris, and
avoiding them.
OPERATE the machine only on surfaces capable
of supporting wheel loads.
NEVER operate the machine when wind speeds
exceed this machines rating. See Beaufort Scale
on page 5 of this chapter for details.
I N C A S E O F E M E R G E N C Y p u s h t h e
EMERGENCY STOP to deactivate all powered
functions.
Climbing up the railing of the platform, standing on
or stepping from the platform onto buildings, steel
or prefab concrete structures, etc., is prohibited!
IF AN ALARM SOUNDS while the platform is
elevated, STOP, and carefully lower the platform.
Move the machine to a firm, level surface.
Bypassing any safety equipment is prohibited
and presents a danger for the persons on the aerial
work platform and its working range.
Dismantling the entry gate or other railing
components is prohibited! Always make certain
that the entry gate is closed and securely locked!
It is prohibited to keep the entry gate in an open
position (held open with tie-straps) when the
platform is raised!
Extending the height or the range of the platform by
placing ladders, scaffolds, or similar devices on the
platform is prohibited!
NEVER perform service on the machine while the
platform is elevated without blocking the elevating
assembly.
INSPECT the machine thoroughly for cracked
welds, loose or missing hardware, hydraulic leaks,
loose wire connections, and damaged cables
before using.
VERIFY that all labels are in place and legible
before using the machine.
NEVER use a machine that is damaged, not
functioning properly, or has damaged or missing
labels.
NEVER charge batteries near sparks or open
flames. Charging batteries emit explosive
hydrogen gas.
Modifications to the aerial work platform are
prohibited or permissible only with the approval of
Snorkel.
AFTER USE, se cure the SP17/SP18 from
un au tho rized use by turn ing the key switches off
and re mov ing the key.
■ Safe Operation
The following safety information is vitally important
for safe operation of the SP. Failure to follow these
instructions can result in personal injury or DEATH.
❑
Pre-start Inspection
At the start of each work shift, the SP shall be given
a visual inspection and function test. See the
Pre-operational Inspection chapter 7, in this
manual for a list of items to inspect and test.
DO NOT op er ate the SP un less you are
trained and au tho rized, un der stand the
op er a tion char ac ter is tics of the SP, and
have in spected and tested all func tions to be
sure they are in proper work ing or der.
❑
Work Place Inspection and Practices
Do not use the SP as a ground for welding. Ground
to the work piece.
Before the SP is used, and during use, check the
area in which the SP is to be used for possible
hazards such as, but not limited to:
● Drop-offs or holes.
● Side slopes.
● Bumps and floor obstructions.
● Debris.
● Overhead obstructions and electrical
conductors.
● Hazardous locations.
● Inadequate surface and support to withstand
all load forces imposed by the aerial platform
in all operating configurations.
● Wind and weather conditions.
● Presence of unauthorized persons.
page 2 - 2 SP17/SP18 – 11972A
Chapter 2. Safety
CAUTION