Snorkel S3219E-sn000017+ - Manual (Page 45)

S3219E/S4732E – 1500834 41
Chapter 10 – Stowing and Transporting
To prevent unauthorized use and damage, properly stow
the aerial platform at the end of each work day. It must
also be properly stowed while transporting.
Stowing
Use the following procedure to properly stow the aerial
platform.
Caution
The extension deck is free to move when the exten-
sion handle locks are disengaged. Personal injury may
result from accidentally extending or retracting the
deck. Make certain both extension handle locks are
fully engaged when the deck is extended in the work-
ing position and when it is stowed. Do not attempt to
extend or retract the platform unless the aerial platform
is on a level surface.
1. Fully retract the platform extension deck and ensure
that it is secured in position, with the latch handles
fully lowered and the locks fully engaged.
2. Fully lower the platform.
3. Push the emergency stop button inward on the lower
control panel.
4. Turn the battery disconnect switch off and lock it.
5. Securely close the swing-out trays.
Transporting
The aerial platform may be moved on a transport vehicle.
Depending on the particular situation, the aerial platform
may be lifted with a forklift, driven, winched, or hoisted
onto a vehicle such as a truck or trailer. Lifting with a
forklift is the preferred method.
The equipment used to load, unload, and transport the
aerial platform must have adequate capacity. The empty
vehicle weight is listed in Chapter 2 and is stamped on
the serial number placard.
The user assumes all responsibility for:
Choosing the proper method of transportation.
Choosing the proper selection and use of transporta-
tion and tie-down devices.
Making sure the equipment used is capable of sup-
porting the weight of the aerial platform.
Making sure all manufacturer’s instructions and warn-
ings, regulations and safety rules of their employer,
the DOT, and/or any other state or federal law are
followed.




Lifting With a Forklift
Use the following procedure to lift the aerial platform with
a forklift.
1. Properly stow the aerial platform.
2. Remove all personnel, tools, materials, or other loose
objects from the platform.
3. If lifting from the rear of the machine, insert the forklift
forks into the pockets (refer to Figure 10.1).
Figure 10.1 – Rear of Chassis
Caution
Lifting the aerial platform with the forklift forks posi-
tioned improperly can produce enough force to dam-
age machine components. When lifting the machine
from the side, place the forklift forks directly under
the designated lift points.
4. If lifting from either side of the machine, place the
forklift forks directly under the designated points un-
der the pothole protector skid (refer to Figure 10.2).
Figure 10.2 – Side of Chassis
5. Do not raise the aerial platform higher than necessary
to transport it. Drive the forklift slowly and carefully
when transporting the aerial platform.
Forklift Pockets
Forklift Lift Points