Snorkel S3219E-sn000017+ - Manual (Page 35)

Chapter 8 – Prestart Inspection
S3219E/S4732E – 1500834 31
0361259
PROPER USE OF SAFETY PROP
TO STORE SAFETY PROP
1. Remove all material from platform.
2. Raise platform until the open height is wide
enough to position the safety prop.
3. Place safety prop in the proper position.
4. Remove hands and arms from scissors area.
5. Lower platform until scissors are supported by
safety prop.
1. Raise platform until the open height is wide
enough to position the safety prop.
2. Place the safety prop in the storage position.
0361259
Death or serious injury
might result if safety prop
is not used and/or
properly positioned. Use
safety prop at all times
when servicing machine
with platform raised.
Proper position for safety prop use
1501475
DEATH OR SERIOUS INJURY WILL RESULT FROM
TIPPING OVER. TO KEEP FROM TIPPING THIS
MACHINE OVER FOLLOW THESE RULES.
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON A SLOPE
GO NO CLOSER THAN
4 FEET (1.2 M) to
ANY DROP OFF
OR HOLE
4 FT
OTHER ACTIONS CAN ALSO CAUSE
THIS MACHINE TO TIP OVER
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT override safety devices.
overload the machine.
stand or sit on guardrails.
attach ropes or chains to guardrails.
carry loads outside the railing or use as a crane.
OK
1. 3. 2.
ALARM MEANS TIPOVER DANGER!
LOWER PLATFORM IMMEDIATELY
DO NOT use this machine without the railings and the
entry gate, chain or bar in place. You could fall
out and hurt or kill yourself.
DO NOT use this machine if it is not working right, or if
any part of it is damaged, worn, or missing.
An accident could cause injury or death.
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
ELECTRICAL SHOCK CAN KILL YOU
This machine is not electrically insulated.
Maintain 10 feet (3.1 m) minimum clearance from electrical power lines and apparatus.
This machine will not protect you from shock.
1501475
SERIAL
NUM BER
M O DEL
NUM BER
EM PTY
VEHICLE
W EIG HT
lbs
kg
M AXIM UM
W HEEL
LO AD
lbs
kg
ENG INE
PO W ERED
M O DELS
hp
kW BATTERY
PO W ERED
M O DELS
V DRIVE
M O TO RS
BATTERIES V
Ah
M O NTH / YEAR
O F M ANUFACTURE
M AXIM UM
PLATFO RM
HEIG HT
RATED
NUM BER O F
O CCUPANTS
M AXIM UM
DRIVE
HEIG HT
ft
m
UNRESTRICTED
PLATFO RM
CAPACITY
lbs
kg
M AXIM UM
ALLO WABLE
W IND SPEED
m ph
m /s
M AXIM UM
PLATFO RM
REACH
ft
m
0070901
Axle w eights w ith m achine in the stow ed position.
lbs
lbs
kg
kg
DRIVE AXLE
STEER AXLE
Do not rem ove any weight from this m achine.
Any weight added m ust be distributed equally on each axle.
M AXIM UM
ALLO WABLE
M ANUAL FO RCE
(SIDE PULL)
lbs
N
Indoors O utdoors
SLO PE SENSO R ALARM SETTING
FRO NT TO BACK deg SIDE TO SIDE deg
M AXIM UM
O UTRIG G ER
LO AD
M AXIM UM
G RADEABILITY %
CHARG ER
INPUT V
Snorkel International
2009 Roseport Road
Elw ood, KS 66024
1-800-255-0317
0070901
Push and release the hand
pum p several tim es to
disengage the brakes.
3.
Turn the free-wheeling valve
fully counterclockwise.The
free-wheeling valve is on
the hydraulic m anifold valve.
4.
After m oving the m achine,
turn the free-wheeling valve
fully clockwise. O perate the
drive function
If brakes do
not reset, refer to the
O perator’s M anual.
verify that the
brakes reset.
6.
DO NO T exceed
( ) when towing.
2 m ph
3.2 km /h
5.
1. Before tow ing, pushing, or w inching, the m achine m ust be on level
ground. R ead and understand all instructions. R efer to the O perator’s
M anual. Turn battery disconnect sw itch to "O FF" position.
TO W IN G IN STR U C TIO N S
D O N O T operate any hydraulic functions
after disengaging the brakes or the brakes
w ill reset, preventing the m achine from
being m oved.
DISENG AG E BRAKES
FREE-W HEELING
VALVE
HYDRAULIC
M ANIFO LD VALVE
Brake
Release
Push down on the Brake Release valve. 2.
Hand
Pum p
Pressure
Relief
Knob
1 3 6 0 5 5 1
WARNING
Tow ing this m achine requires disengaging the brakes. Follow instruction
below w hen tow ing, pushing, or w inching this m achine. Verify the brakes
have been reset after m oving m achine and before operating the m achine.
D EATH O R SER IO U S IN JU RY C O U LD R ESU LT
FR O M U N C O N TR O LLED M O TIO N .
1360551
Right Side
Rear
0070901
(Inside Rear Compartment)
1501475
0361259
300760
300760
DANGER
Trays must be closed when platform is elevated.
TIPOVER HAZARD
300760
DEATH OR SERIOUS INJURY MAY
RESULT IF MACHINE TIPS OVER
1360551
1501476
1501476
DEATH OR SERIOUS INJURY WILL RESULT FROM
TIPPING OVER. TO KEEP FROM TIPPING THIS
MACHINE OVER FOLLOW THESE RULES.
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON
SOFT OR UNEVEN
SURFACES
DO NOT RAISE THE PLATFORM
IN WIND ABOVE 28 MPH (12.5 M/S)
OTHER ACTIONS CAN ALSO CAUSE
THIS MACHINE TO TIP OVER
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
ELECTRICAL SHOCK CAN KILL YOU
Allow for platform sway, rock, or sag. If voltage is 300 V to 50 kV, stay at least
10 feet (3.1m) away. If voltage is more than 50 kV, talk with your supervisor or read the Operator's Manual
on this machine for safe distances.
1501476
DO NOT
DO NOT
let an untrained or unauthorized person use this
machine. When leaving the machine unattended,
remove the key, turn the battery disconnect switch
off, and lock it in the off position.
replace components critical to machine stability,
such as batteries and wheels, with lighter weight or non-factory approved substitutes.
TO AVOID
TIPOVER HAZARDS
USE ON
FLAT, LEVEL, AND
SOLID SURFACES
ONLY 4 FT
OK
DO NOT
DO NOT
DO NOT
ride platform while machine is on a truck, fork lift
or other device.
use ladder, scaffold, or other means to increase
size or platform height.
use with damaged tires or wheels.