Chapter 5 – gauges and displays – Snorkel S3219E-sn000017+ User Manual
Page 17
S3219E/S4732E – 1500834
13
The aerial platform is equipped with several gauges to
monitor the condition of the machine before and during
operation.
Battery Charge Indicator
The battery charger has three LED’s (refer to Figure 5.1)
which indicate the charger status.
Figure 5.1 –Rear of Chassis
The LED’s are visible on the battery tray.
• 30% red LED blinking – indicates that the batteries
are 0% to 30% charged.
• 60% red LED blinking – indicates that the batteries
are 30% to 60% charged.
• 90% red LED blinking – indicates that the batteries
are 60% to 90% charged.
• 100% green LED solid On – indicates that the charge
cycle is complete.
Battery Condition Indicator
The battery condition indicator (refer to Figure 5.2) is
located on the top of the upper control panel. When the
light comes on, the lift function is cut out and drive speed
is reduced to slow.
Figure 5.2 – Top of Upper Controls
Diagnostic Center Display
The diagnostic center LCD display (refer to Figure 5.3)
is located in the control valve tray on the right side of the
machine.
Figure 5.3 – Diagnostic Center LCD Display
When the battery disconnect and emergency stop but-
ton at the lower controls are in the on position, the LCD
display shows:
• The accumulated aerial platform operating time
• The available battery power to operate the machine.
Chapter 5 – Gauges and Displays
LED Charge Indicators
Battery Condition Indicator