Caution, Placards and decals, Chapter 8 – prestart inspection – Snorkel S2033CE User Manual
Page 32: Figure 8.21 – front of platform floor, Right side
![background image](/manuals/549905/32/background.png)
Chapter 8 – Prestart Inspection
28
S2033 – 330003EE
Figure 8.21 – Front of Platform Floor
480658
Right Side
300760
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition, and
are legible. The placards and decals may be cleaned
with soap and water, and a soft cloth if the words or pic-
tures cannot be seen.
A
Caution
Solvents may contain hazardous ingredients. Fol-
low the manufacturer’s label for proper use and dis-
posal. Wear protective gloves and splash-proof
safety glasses when using solvents.
Wet paint overspray may be removed using a natural bio-
degradable solvent and a soft cloth. Replace any miss-
ing or illegible placards or decals before operating the
aerial platform. Placard and decal kits are available from
Snorkel.
The safety related placards and decals are illustrated on
the following pages.
DEATH OR SERIOUS INJURY CAN RESULT FROM TIPPING OVER.
TO KEEP FROM TIPPING THIS MACHINE OVER FOLLOW THESE RULES.
OTHER ACTIONS CAN ALSO CAUSE THIS MACHINE TO TIP OVER
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
480658
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT
override safety devices.
overload the machine.
stand or sit on guardrails.
attach ropes or chains to guardrails.
carry loads outside the railing or use
as a crane.
DO NOT use this machine without the railings and the
entry gate, chain or bar in place. You could
fall out and hurt or kill yourself.
DO NOT use this machine if it is not working right, or if
any part of it is damaged, worn, or missing.
An accident could cause injury or death.
DO NOT
DO NOT
let an untrained or unauthorized person use this
machine. When you leave the machine unattended,
remove the key, or turn off the battery switch on the base
of the machine and lock the battery switch in the off
position.
replace components critical to machine stability, such as
batteries and wheel equipment, with lighter weight or
DO NOT
DO NOT
DO NOT
ride platform while machine is on a truck, fork lift
or other device.
use ladder, scaffold, or other means to increase
size or platform height.
use with improperly inflated or damaged tires or
wheels.
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON
SOFT OR UNEVEN
SURFACES
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON A
SLOPE
GO NO CLOSER THAN 4 feet (1.2m)
to ANY DROP OFF
OR HOLE
4 FT
OK
1.
3.
2.
TWO-TONE ALARM MEANS TIPOVER DANGER!
LOWER PLATFORM IMMEDIATELY
TO AVOID
TIPOVER HAZARDS
USE ON
FLAT, LEVEL, AND
SOLID SURFACES
ONLY
4 FT
OK
ELECTRICAL SHOCK CAN KILL YOU
This machine is not electrically insulated. Maintain 10 feet minimum
clearance from electrical power lines and apparatus.
Allow for platform sway, rock, or sag. If voltage is 300 V to 50 kV stay at least
10 feet (3.1m) away. If voltage is more than 50 kV talk with your supervisor
or read the Operator's Manual on this machine for safe distances.
This machine will not protect you from shock.
DO NOT RAISE A PLATFORM
WHEN IT IS
WINDY
OR
GUSTY
480658
300760
Lanyard Anchor