Snorkel X Series-sn6013-15019 - Manual (Page 8)

8
Charge batteries in a well ventilated area.
Do not charge batteries when the work platform is
in an area containing sparks or flames.
Permanent damage to batteries will result if batter-
ies are not immediately recharged after discharging.
Never leave charger operating unattended for more
than two days.
Never disconnect cables from batteries when
charger is operating.
Keep charger dry.
1. Check battery fluid level. If electrolyte level is lower than
3/8 in. (10 mm) above plates add distilled water only.
2. Connect extension cord (12 gauge (1.5 mm²) conductor
minimum and 50 ft. (15 m) in length maximum) to the
charger outlet plug located at the rear of the machine.
Connect other end of extension cord to properly
grounded outlet of proper voltage and frequency.
3. Charger turns on automatically after a short delay, the
ammeter will indicate DC charging current.
4. Charger turns off automatically when batteries are fully
charged.
Battery Maintenance
Hazard of explosive gas mixture. Keep sparks,
flame and smoking materials away from batteries.
Always wear safety glasses when working with
batteries.
Battery fluid is highly corrosive. Rinse away any
spilled fluid thoroughly with clean water.
Always replace batteries with UpRight batteries or
manufacturer approved replacements weighing 62
lbs. each.
Check battery fluid level daily, especially if work platform is
being used in a warm, dry climate.
If electrolyte level is lower than 3/8 in. above plates add
distilled water only. DO NOT use tap water with high mineral
content it will shorten battery life.
Keep terminals and tops of batteries clean.
Refer to the Service Manual to extend battery life and for
complete service instructions.
Battery Charging
Charge batteries at end of each work shift or sooner if
batteries have been discharged.
Figure 10: Battery Module
Figure 9: Battery Charger
Ammeter
Battery Charger
Charger Plug
(Behind Guard)