Snorkel SPX10 - Manual (Page 19)

OPERATOR’S MANUAL with Maintenance Information
Function Tests
15
1 Select a test area that is firm, level and free
of obstruction.
2 Be sure the battery pack is connected.
3 Pull out the platform and ground red
Emergency Stop buttons to the on position.
4 Turn the key switch to power on.
☉ ☉ ☉ ☉ Result: The Power indicator will light.
Test Emergency Stop
5 Push in the ground red Emergency Stop
button to the off position.
☉ ☉ ☉ ☉ Result: The Power indicator will turn off and
no functions should operate.
6 Pull out the red Emergency Stop button to
the on position.
At the Platform Controls
Test Emergency Stop
7 Push in the platform red Emergency Stop
button to the off position.
☉ ☉ ☉ ☉ Result: No functions should operate.
8 Turn the red Emergency Stop button
clockwise to the on position.
Test the On-off function
9 Press the on-off button to power on.
☉ ☉ ☉ ☉ Result: the power indicator should light.
10 Press the on-off button to power off.
☉ ☉ ☉ ☉ Result:. No functions should operate.
11 Press the on-off button to power on.
Test Up/Down Functions and Function
Enable
12 Press the on-off button to power off.
13 Move the joystick forward or backward
☉ ☉ ☉ ☉ Result: The platform should not raised.
14 Press the On-off button to power on.
15 Press the mode button to select lift function.
16 Move the joystick to forward direction.
☉ ☉ ☉ ☉ Result: The platform should raise.
17 Move the joystick to backward direction.
☉ ☉ ☉ ☉ Result: The platform should lower then stop
at the height is 0.7 m.
18 Wait for seconds. Move the joystick to
backward direction to lower the platform
fully
Test the Steering
Note: When performing the steer and drive
function tests, stand in the platform facing the
steer end of the machine.
19 Press the mode button to select drive
function.
20 Move the joystick to left direction.
☉ ☉ ☉ ☉ Result: The steer wheels should turn. The
machine should turn to left.
21 Move the joystick to right direction.
☉ ☉ ☉ ☉ Result: The steer wheels should turn. The
machine should turn to right.
Test Drive and Braking
22 Slowly move the joystick to forward
direction, then return the joystick to the
center position.
☉ ☉ ☉ ☉ Result: The machine should move forward
then come to an abrupt stop.
23 Slowly move the joystick to downward
direction, then return the joystick to the
center position.
☉ ☉ ☉ ☉ Result: The machine should move backward
then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.