Addictive Desert Designs 2009 - 2013 F-150/Raptor Venom Chase Rack User Manual
Page 2
2. Mark the 6 hole locations with sharpie and move the chase rack out of the away.
3. Drill the 6 marked holes with the ½” drill bit and drill. Clean of any burrs in the plastic with utility
knife.
***If you purchased lights that fit into the Chase Rack, now is a good time to do the install. ****
4. Fit the Chase Rack onto the truck and attach using the supplied ½” x 1 ½” Bolts (4 ea.), ½” Nuts
(4 ea.) and ½” Flat Washers (8 ea.). Leave finger tight until all of the bolts are installed, then
tighten to 70 ft./lbs..
5. Step back and enjoy your new A.D.D. Venom Chase Rack.
6. Check, and re-tighten if needed, all mounting bolts after 100 miles and periodically thereafter.