Addictive Desert Designs 2009 - 2013 F-150/Raptor Venom Rear Bumper User Manual
Page 2
***If you purchased lights that fit behind the bumper, now is a good time to install those into
the bumper****
3. Fit the bumper back onto the truck and attach using the supplied ½” x 1 ½” Bolts (4 ea.), ½” Nuts
(4 ea.) and ½” Flat Washers (8 ea.) and the two lower 10mm factory bolts. Leave finger tight
until all of the bolts are installed, then tighten the ½” Bolts to 70 ft./lbs. and the 10mm Bolts to
25 ft./lbs.
4. Fit License plate light assembly, license plate, and back-up sensors (if equipped).
5. Step back and enjoy your new A.D.D. bumper.
6. Check, and re-tighten if needed, all mounting bolts after 100 miles and periodically thereafter.
For additional support or technical questions,
please call 480.671.0820 or
email
Addictive Desert Designs
4840 E. Jasmine Street Suite 112
Mesa, AZ 85205