Addictive Desert Designs 2007 - 2013 Jeep JK Stealth Fighter Front Bumper User Manual
Page 2

INSTALLATION INSTRUCTIONS
1. Remove stock bumper.
2. Install winch fair lead onto the new ADD bumper.
a. Use a 19mm socket
3. Now you will want to bolt your top light bar hoop onto you’re A.D.D Stealth Fighter bumper.
4. Next you will install your 20” light bar to the new A.D.D bumper. If you did not purchase the
light bar you can move on to next step. (light bar sold separately)
5. Now you will place the main center piece on your Jeep. You will want to place the top bolts on
each side to hold in place. Once they are in, now put the bottom two in and tighten your top
bolts. See the access holes below.