Addictive Desert Designs 2009 - 2013 F-150/Raptor Stealth Fighter Front Bumper User Manual
Page 2
***If you purchased lights that fit behind the bumper, now is a good time to install those into
the bumper****
3. Now you will want to unbolt your tow guards and move back one hole.
4. Fit the bumper back onto the truck and attach using the supplied ½” x 1 ½” Bolts (8 ea.), ½” Nuts
(8 ea.) and ½” Flat Washers (12 ea.). Leave finger tight until all of the bolts are installed, then
tighten to 70 ft./lbs.
***The Upper outside holes will not be used and the holes will be kept open.***
5. Attach the lower section using the 2 – 15mm
Skid Plate Bolts taken from the factory skid
plate.