For additional support or technical questions – Addictive Desert Designs 2009 - 2013 F-150/Raptor Race Series R Front Bumper User Manual
Page 2
***If you purchased lights that fit behind the bumper, now is a good time to install those into
the bumper****
3. Fit the bumper back onto the truck and attach using the supplied ½” x 1 ½” Bolts (8 ea.), ½” Nuts
(8 ea.) and ½” Flat Washers (16 ea.). Leave finger tight until all of the bolts are installed, then
tighten to 70 ft./lbs. Make sure the alignment cam slot is over the lower control arm bolt.
***The Upper outside holes will not be used and the holes will be kept open.***
***Make sure the alignment cam provided is in the alignment slot, and tighten from the back.
(See Picture included)
4. Step back and enjoy your new A.D.D. bumper.
5. Check, and re-tighten if needed, all mounting bolts after 100 miles and periodically thereafter.
For additional support or technical questions,