Smittybilt 76653 Rear Bumper User Manual
Rear bumper template instructions
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Rear Bumper
Template Instructions
(76750, 76750D, 76651, 76651D,76653)
Step 1: Raise the frame drill template into place by locating it on the rear frame
cross member OE bumper outer mounting holes. NOTE: The notch will be on the top and the
drill template will be flipped for use on both the driver and passenger side.
Step 2: Using the supplied drill template, making sure its straight mark the needed holes with a scribe or
marker then proceed to drill the (4) holes in the frame using a 7/16” drill bit.
CAUTION!
Be VERY CAREFUL not to drill into the fuel tank. Use a drill stop on
the drill bit to prevent the drill bit from over penetrating.