Smittybilt 7310xx Tonneau Cover - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Tonneau Cover
Part #’s 7110xx, 7310xx
76-91,CJ7 & Wrangler, 92-95 Wrangler
(With Hardtop or Softop Hardware Removed)
INSTALLATION TIPS
1. It is recommended to install this part when temperatures are above 72 degrees F. The material can
contract up to an inch making it difficult to install, especially the first time. It is designed to be tight to
eliminate flapping.
2. Any wrinkles will eventually go away once the material is “relaxed”
Step 1: Make sure all Hardtop and Softop Hardware is removed from the body tub. Using rubbing alcohol
or some other solvent clean the beveled edge around the body tub to help insure good adhesion of
the Velcro.
Step 2: Starting on one side of the vehicle begin peeling the back off of the Velcro and sticking it near the
top edge of the beveled edge along the body. (Fig A)
Step 3: Continue around the back of the vehicle, across the tailgate and towards the opposite side you
started on. Note: You will need to cut the Velcro at each end of the tailgate. It also helps to cut
small slits in the Velcro when going around the corners. (Fig B)
(Fig A) (Fig B)
Step 4: Make sure Velcro is attached securely before installing Tonneau. Lay the Tonneau cover over the
vehicle. Open each side of the Tonneau cover in order for it to fit around your sport bar. Do not
fasten at this time. (Fig C)
Step 5: Beginning on the rear drivers side: begin attaching Velcro. Work towards the front, pulling the
Tonneau towards you. Repeat on the passenger side.
Note: Please read instructions entirely before installing this part.
It also helps to cut small slits
in the Velcro when going
around the corners.