Smittybilt 56613xx G.E.A.R. (Truck) Seat Cover - Manual

www.smittybilt.com
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W. Artesia Blvd, Compton, CA 90220
Installation Instructions
G.E.A.R. (Truck) Seat Cover
Part # 56613xx (Universal Fit)
Parts Included Qty Parts Included Qty
Seat Covers 2 Separate Pouches 6
Note:
Each cover has two sewn-on large storage pouches. There is also six multi-purpose pouches total that
gives you plenty of flexibility in placing them on the covers.
STEP 1:
Remove headrest from seat if applicable. Release the cord clip and slide it down.( Fig A)
This will create slack; next proceed to slide the cover down over your seat.
STEP 2:
If your seat does not have any factory parts on it (arm rests, levers, air bags, ect) continue
to pull the seat cover down. When you have determined the correct position simply
pull the draw strings snug and slide up the plastic cord clip. Installation is now
complete. (Fig A) See step 4 for pouch installation.
STEP 3:
If your seat is equipped with some kind of factory part slide the plastic cord clip all the
way down and remove it. Remove the cord from the webbing loops in the area of the
factory part.(Fig B)When you have determined that you have enough room for the factory
part slide the cord straight down through the webbing loops until you have cleared the
factory part. (Fig C) Once below the part you can start the criss-cross design again until
you have reached the bottom of the cover. Re-install your headrest if equipped, (Fig D)
Re-install the cord clip, adjust cover to the optimal position and then pull the cord snug
and slide the cord clip up. Make sure all seat functions work properly. Installation is
now complete. (Fig E,) See step 4 for pouch installation.
(Fig A) (Fig B) (Fig C)
Carefully read the following installation instructions and tips for ease of installation.
Cord Clip
Slide the cord
straight down
through the
webbing loops on
both sides until
you have cleared
the factory part