Smittybilt TN1130-S4 SIDE STEP - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
SIDE STEP (Part # TN1130-S4)
01-04 Toyota Tacoma Crew Cab
PARTS LIST
1- PASSENGER SIDE BAR 2- FRONT MOUNT BRACKETS
1- DRIVER SIDE BAR
2- REAR MOUNT BRACKETS
8- M10X25 HEX BOLTS 8- Ø10 FLAT WASHERS
8- Ø 10 LOCK WASHERS 12- M8X30 HEX BOLTS
12- M8 HEX NUTS 12- Ø8 FLAT WASHERS
12- Ø 8 LOCK WASHERS
ISTALLING THE FRAME BRACKETS TO SIDE BAR
ATTACH THE DRIVER SIDE FRONT AND REAR BRACKETS TO DRIVER SIDE BAR USING
HARDWARE SUPPLIED IN LIST REFER TO DIAGRAM THE BRACKETS BOTH FACE TOWARDS
EACH OTHER AS IN DIAGRAM.
ISTALLING THE SIDE BAR TO FLOOR RAIL
YOU WILL NEED ONE PERSON TO HELP YOU HOLD THE SIDE BAR UP TO FLOORBOAD TABS
ONCE YOU’VE GOT THE SIDE BAR IN PLACE BEGIN TO INSTALL ALL HARDWARE PLACE M10
BOLTS WAHSERS LOCK NUTS IN REAR BRACKET MIDDLE HOLE OF BRACKET AND M8 HEX
BOLTS WASHERS NUTS IN TWO REMAINING HOLES HAND TIGHTEN AS YOU WILL HAVE TO
ALIGN BAR . AT FRONT SECTION OF BAR TAKE M10 BOLTS WASHERS LOCK NUTS PLACE IN
MIDDLE HOLE. AND M8 BOLTS WASHERS NUTS IN REMAINING HOLES ALIGN BAR BEGIN TO
TIGHTEN ALL BOLTS.
AS WITH PRODUCT IT IS RECOMMENDED TO CHECK ALL NUTS AND BOLTS FOR
TIHGTENESS AFTER DRIVING.
Cleaning and Maintenance
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap,
window or glass cleaner may be used also.
For gloss black finishes: Mild soap, window and glass cleaner may be used.