Smittybilt DN240-S4 Sure Steps - Manual (Page 2)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Sure-Step (Part # DN240-S4)
02-07Dodge Ram Quad Cab
Front of 02-05 shown.
Spacer Plate
12x120mm
Bolt
(Figure 1) (Figure 2)
Step 4: Place the side bar into position. Attach bar to brackets using the ½ “ x 2” bolts, flat washers and lock
washers. To determine which side bar is Left or Right, check the letter stamped on the welded insert
at the inside of the end of the tube. Note: Be sure to install the plastic ring between the bar end and
bracket.
Step 5: Remove tape covering the rear hole in the vehicle body. (If applicable) Now place the rear bolt plate
into hole. (Figure 3) Attach the rear support bracket to the rear bar bracket and the body of the
vehicle using the supplied 3/8” hardware. (Figure 2)
Front of 06-07
models shown.
(Figure 3) (Figure 4)