Smittybilt CN110-S2S Sure Steps - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Sure-Step (Part # CN110-S2)
88-98 C/K Pickup Standard Cab/95-99
Tahoe/Yukon 2 Dr
QTY DESCRIPTION
1
Side Bar, left side
1 Side Bar, right side
1 Hardware Kit
NOTE:
Please read this information before installing. Check components received with components listed
above. NO DRILLING REQUIRED for installation of these side bars. To obtain correct
installation we recommend you to follow these step by step installation instructions carefully. Please take care
when installing this product to protect the finish and your investment.
Step One: Locate hardware and check contents with the hardware listed below.
QTY
DESCRIPTION
4
12mm x 120mm x 1.75mm hex bolts, 8.8
4 12mm flat washers, zinc plated
4 12mm split lock washers, zinc plated
4 12mm x 50mm hex bolt, zinc plated GR5
4 12mm flat washers, zinc plated
4 12mm split lock washers, zinc plated
1 801086L front support bracket, left side
1 801086R front support bracket, right side
1 801178L rear support bracket, left side
1 801178R rear support bracket, right side
Step Two: Locate the left side bar, one 801086L support bracket, one 801078L support bracket, two #30 plastic
rings, two 12mm hex bolts, 12mm flat washers and two 12mm split lock washers. Secure the brackets and rings
to the side bar as shown in fig #1. When installing side bar on pickup truck you must use the two lower mounting
holes on bracket 801178. Do not fully tighten hardware at his time.
Step Three: Locate two 12mm hex bolts, two 12mm flat washers and two 12mm split lock washers. Remove the
front and rear cab mount bolts located under the cab. Place the side bar under the vehicle and position each
support bracket under the cab mounts. Secure the support brackets to the bottom of the cab mounts as shown in
fig #2 & 3. Fully tighten all hardware at this time. Torque the 12mm x 120mm bolt to 50 ft. lbs, and the 12mm x
50mm to 30 ft lbs.