Smittybilt 55114 Bull Bar - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Bull Bar (#55113&55114)
08 Ford Super Duty
PARTS LIST:
1 Bull Bar 4 10-1.50mm x 30mm Hex Head Bolts
1 Driver/Left side Mounting Bracket 4 10mm Nylock Nuts
1 Passenger/Right Mounting Bracket 8 10mm ID x 25mm OD x 3mm Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It is not
required, but strongly recommended. If local/state law requires a license plate, license plate relocation
kit is available.
3. From front of vehicle remove the driver side bumper mount bolts (Figure 2). WARNING! Do not
remove passenger and driver bumper mount bolts at the same time. Remove one side at a time.
4. Place Mounting Bracket onto vehicle and line it up against the outer gusset bend on the frame. Leave
about 1/8” clearance between bottom of Mounting Bracket and bumper. Secure Mounting Bracket to
vehicle using the factory bolts (Figure 3). Fully tighten these bolts at this time.
5. Once the driver side Mounting Bracket is fully tightened, repeat steps 2 - 4 for passenger side
Mounting Bracket.
6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting
Brackets using the included (4) 10mm x 30mm Hex Head Bolts, (4) 10mm Nylock Nuts, and (8) Flat
Washers (Figure 4). Do not tighten at this time.
7. Level and adjust Bull Bar as desired, then tighten all hardware at this time.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight..
Driver Side
Mounting Bracket
Passenger Side
Mounting Bracket
Figure 1