Smittybilt 54032 Bull Bar - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
BULL BAR (Part # 54031&54032)
07 Toyota Tundra
PARTS LIST:
1 Bull Bar 4 12mm lock Nuts
4 12-1.75mm x 30mm Hex Head Bolts 8 12mm Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Locate and remove the factory tow hooks underneath the vehicle (Figure 2). Save hardware
for later use.
3. Locate Passenger Side Mounting Bracket and loosely attach it to vehicle by using the factory
bolts removed in step two (Figure 3). Passenger Side shown in Figure 3. Repeat this step for
Driver Side Mounting Bracket.
4. Once the Mounting Brackets are loosely installed, with help position the Bull Bar on the outer
side of the Mounting Brackets and attach it with the included (4) 12-1.75 mm x 30mm Hex
Head Bolts, (4) 12mm Nylock Nuts, and (8) 12mm Flat Washers (Figure 3).
5. Level and adjust the Bull Bar and tighten all hardware at this time.
Figure 1
Figure 2 Figure 3
12mm Hardware
Factory Bolts
Driver Side
Bracket
Passenger
Side Bracket
Remove
these bolts