beautypg.com

Smittybilt 17491 Bolt-On Fender Flares User Manual

Page 4

background image

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

Bolt-On Fender Flares

Dodge Ram 1500 (09-12)

Part #17491

REAR FENDER FLARE INSTALLATION





STEP 11:

Attach 11 bolts to each Fender Flare using a

5/32” Allen key and a 3/8” wrench/socket. (wrench/socket
and Allen key not supplied)

STEP 12:

Attach the included rubber seal to the

Fender Flares. Peel back 2” of the adhesive backing and
position on the Fender Flare. Attach the seal to the
fender flare, peeling back a few inches at a time. Attach
rubber seal along all areas the Fender Flare will make
contact with the vehicle body. Trim any excess rubber
seal.

STEP 14:

Remove all factory bolts and retain for

installation of Fender Flares.

For models equipped with factory fender flares, removal
of factory flares is required, please consult the vehicle
service manual for factory fender flare removal.
Place the Fender Flares on to the vehicle and fit into the
correct position following the contours of the body.

STEP 13:

Clean the body areas where the Fender

Flares will makes contact. Use the supplied alcohol wipe.