Smittybilt 17391 Bolt-On Fender Flares - Manual (Page 4)

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Bolt-On Fender Flares
Ford F250/F350 (08-10)
Part #17391
REAR FENDER FLARE INSTALLATION
STEP 9: Attach 10 bolts to each Fender Flare using a
5/32” Allen key and a 3/8” wrench/socket. (wrench/socket
and Allen key not supplied)
STEP 10: Attach the included rubber seal to the
Fender Flares. Peel back 2” of the adhesive backing and
position on the Fender Flare. Attach the seal to the
Fender Flare, peeling back a few inches at a time. Attach
rubber seal along all areas the Fender Flare will make
contact with the vehicle body. Trim any excess rubber
seal.
STEP 12: Place the Fender Flare onto the vehicle and
fit into the correct position following the contours of the
body. Use ten (10) of the .6mm clips (five (5) per side) to
secure the Fender Flare to the body. Make sure the
dimple in the clip securely attaches in the slot on the
Fender Flare.
STEP 11: Clean the body areas where the Fender
Flares will makes contact. Use the supplied alcohol wipe.
For models equipped with factory fender flares, removal
of factory flares is required, please consult the vehicle
service manual for factory fender flare removal.