Synergy 8095-01 - Jeep JK Front Track Bar Brace (RHD) - Manual (Page 6)

10) Lastly, torque the 9/16-18 UNF track bar bolt (1) to 125 ft-lbs (**NOTE** Skip
this step if installing 8095-02 Sector Shaft Brace as well, this will be mentioned
again in Step 18)
11) The remainder of the steps in these instructions will cover the installation of the
8095-02 RHD JK Sector Shaft brace
o Begin by removing the pitman arm nut (#3 in image below)
12) With pitman arm nut removed, install the sector shaft brace as shown below.
Take note, you will be reusing the factory lock washer. Slide the new pitman arm
stud into the bearing housing as shown. (Hex on bottom)
o NOTE – We suggest putting a dab of anti-seize on the threads of the sector
shaft to prevent galling / seizing at a later time. This will also help
provide more accurate torque measurements.