Instructions – Synergy 8095-01 - Jeep JK Front Track Bar Brace (RHD) User Manual

Page 2

Text mode
Original mode

• 1 – M14-2.0 x 80mm long track bar bolt
• 1 – M14-2.0 top lock nut

**Note** 2012 and up models retaining the stock track bar, must use the metric 14mm
hardware provided

8095-02

• 1 – PPM-8095-02 RHD Sector Shaft Brace (Needle Bearing and grease zerk

installed)

• 1 – Pitman Arm Stud
• 1 – 7/16-14 UNC x 3/4” long bolt
• 2 – 7/16-14 UNC top lock nuts
• 2 – 7/16-14 UNC x 1” long flat head socket cap screws
• 3 – 7/16” flat washers

INSTRUCTIONS:

1) Remove the nut and bolt (2) from the TB bracket.

2) After removing the TB bolt from the frame, raise and support the vehicle using

jack stands so the axle can swing freely. Having the suspension at droop makes
installation much easier. Remove the driver front tire.