Synergy 8069 - Jeep JK Front Track Bar Brace - Manual (Page 8)

8) Torque the 4 steering box bolts (1) to 70 ft-lbs
9) Torque the two 7/16” bolts installed in step 6 to 50 ft-lbs
10) Lastly, torque the 9/16-18 UNF track bar bolt (1) to 125 ft-lbs (**NOTE** Skip
this step if installing 8069-02 Sector Shaft Brace as well, this will be mentioned
again in Step 18)
11) The remainder of the steps in these instructions will cover the installation of
8069-02 JK Sector Shaft Brace.
a. Begin by removing the pitman arm nut (#3 in image below)