Synergy 8069 - Jeep JK Front Track Bar Brace - Manual (Page 2)

GENERAL NOTES:
• These instructions are also available on our website at
www.synergymfg.com .
Check the website for any updated instructions and additional photos for
reference.
• The installation of this kit can be done with simple hand tools with the vehicle
sitting on the ground under its own weight.
• Proper bump stop spacers are strongly recommended to prevent damage from
possible track bar / steering box contact. (See step 17 for detailed information)
• Steps 1-10 covers the installation of 8069-01 Track Bar Brace. Installation is
complete after Step 10 if 8069-02 Sector Shaft Brace is not being installed.
• Steps 11-20 covers the installation of 8069-02 Sector Shaft brace. 8069-02
cannot be installed without a 8069-01 Track Bar brace. It is a modular system
which works together to strengthen the drivers side Track Bar / Steering Box
mounting locations.
INSTRUCTIONS:
1) Begin by raising and supporting the vehicle so the axle can swing freely.
2) Remove the nut and bolt (2) from the TB bracket.
3) Remove the 4 steering box bolts shown (1)
o Note – reach under the steering box and support it as the last bolt is
removed. Rest the steering box on the top of the frame as shown.