Synergy 8069 - Jeep JK Front Track Bar Brace - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM 8069
JK FRONT TRACKBAR BRACE / SECTOR
SHAFT BRACE
INSTALLATION INSTRUCTIONS
**DISCLAIMER** The Synergy Manufacturing 8069 system is designed around an
8075 Synergy Manufacturing Track Bar and we cannot guarantee compliance with any
other manufacturer’s track bar. That said, the 8075 Track Bar bends up in a similar
fashion as a stock track bar does, so many other manufacturers track bars are compatible.
-No Bump Stop Spacers are required if using a Synergy 8075 Track Bar.
PARTS LIST:
8069-01
• 1 - PPM-8069-01 Front Track Bar Brace
• 1 - 9/16-12 UNC x 3.25” long track bar bolt
• 1 – 9/16-12 UNC top lock nut
• 2 - 7/16-14 UNC 1” bolts
• 4 - 7/16 flat washers
• 2 - 7/16-14 UNC top lock nuts
• 1 – M14-2.0 x 80mm long track bar bolt
• 1 – M14-2.0 top lock nut
**Note** 2012 and up models retaining the stock track bar, must use the metric 14mm
hardware provided
8069-02
• 1 – PPM-8069-02 Sector Shaft Brace (Needle Bearing and grease zerk installed)
• 1 – Pitman Arm Stud
• 1 – 7/16-14 UNC x 1” long bolts
• 3 – 7/16-14 UNC top lock nuts
• 2 – 7/16-14 UNC x 1” long button head cap screws
• 6 – 7/16” flat washers