Synergy 8009-30 - Jeep JK Front Axle Outer Shell Kit - Manual (Page 3)

6. Cut off the lower control arm brackets and shock mounts. These will not be
reused so try to cut most of the weld bead off the tube so you will have less to grind
off.
7. Cut off the upper control arm bracket. The upper control arm bracket will be re-
used so try to just cut along the top edge of the weld bead on the side of the upper
control arm bracket. This will compensate for the 1/4” thick shell that will go under
it.
8. Grind all the of weld smooth from the axle tube. It should look something like this
when you’re done, these are the parts you will need to reuse